- GNSS for Automotive & Industrial
Model
GN-84A
- Discontinued Products
GN-84A is ideal for a wide range of applications where performance, time to market and ease of integration are prime considerations. It includes two SAW filters for high performance when integrated with wireless communications, and has advanced features for use in car navigation devices and fleet management.
GN-84A is based on OPUS III technology and includes the OPUS IIIez BB IC and the Prelude III RF Receiver IC, a TCXO, two SAW filters and various matching and peripheral components in a small form factor. It is your complete GPS solution with only an external GPS antenna and power supply required.
- GNSS (Timing, Automotive/Industrial)
Features
Provides PVT (Position, Velocity, & Time) in a single package solution.
Antenna current detection circuit
Ultra-high sensitivity (-160dBm Typical).
Quick TTFF (Hot start: 2 seconds Typical).
Low profile, small SMT package reducing the mounting area and mounting cost.
Small footprint: 22mm x 22mm
Well-accepted by automotive electronics device manufacturers thanks to its reliability
Furuno’s powerful navigation software is integrated
Specifications
General
GPS L1 C/A
12ch
1Hz
Acquisition (Hot start) : -160 dBm
Hot start : 2 sec
Warm start : 33 sec
Cold start : 38 sec
(Time after power-on at Ta=25°C, -130dBm, Open sky.)
In case internal LDO is used to supply VCORE
VCC : 3.3V ±0.3V
In case VCORE is supplied from external LDO
VCC : 3.3V ±0.3V , VCORE : 1.2V ± 0.6V
In case internal LDO is used to supply VCORE
ICC : 73mA (typical, While acquiring satellites)
In case VCORE is supplied from external LDO
ICC : 29mA , ICORE : 43mA (typical, While acquiring satellites)
Voltage : 1.8 V to 3.6V DC
Current : < 20 micro A (VCC=0V)
: < 2 micro A (VCC=3.3V)
-30°C to +85°C
-40°C to +85°C
Short and Open Detection
22.0 mm (W) x 22.0 mm (D) x 3.0 mm (H)
NMEA0183 /FEC Binary
Single Serial UART
3 Volt CMOS Digital Levels
Drawing
Inquiries about GNSS Products
- Specifications subject to change without notice.
